Products

PRESERVATIVE, OIL, DIRT ANTI-MOISTURE ELECTRICAL SOLVENT

DEWY-GUARD

PRESERVATIVE, OIL, DIRT ANTI-MOISTURE ELECTRICAL SOLVENT

"PRESERVATIVE, OIL, DIRT ANTI-MOISTURE ELECTRICAL SOLVENT"

PROVIDES EFFECTIVE PROTECTION
After application, it covers the surface with a flexible, non-brittle film layer. This layer prevents water, oil and dust from adversely affecting the performance of working components. Due to the fact that the resulting layer is not flexible and brittle, it is not possible to form tears on the film layer in contact with liquids.

IT SAVES ENERGY

Contactors and electrical devices protected by DEWY-GUARD operate with full performance during the protection period. Due to the fatigue of the system due to oil, dust and humidity, it prevents excessive energy use. DEWY-GUARD is also used for the recovery of water-exposed engines without the need for any other processing. Due to the ability to get between water and metal, the submerged electrical components become operational again with the DEWY-GUARD application after Decontamination. It provides time and economic savings.

METAL AND MOLD PROTECTOR
Since the film layer it forms is also resistant to the effects of salt water, it is also used safely for the protection of sensitive metal parts. It provides complete insulation against all kinds of effects on the materials in question, including humidity and humidity of the air and acid vapors in the indoor environment.

LONG-TERM PROTECTION
Surfaces that have been cleaned and DEWY-GUARD applied are protected for 3-4 months in high humidity and severe conditions, which will shorten the annual maintenance period.

AREAS OF USE
It is used for the protection of contactors, electric motors, generators, control panels, batteries, transformers and metal components exposed to moisture.

INSTRUCTIONS FOR USE
The surface to be applied DEWY-GUARD must first be cleaned with SAFETYSOL. After drying, the application is made so that the entire area is covered and dried with compressed air. In the cleaning of parts damaged due to waterlogging or excessive humidity; Cleaning of parts with pressurized steam or water to clean the sediment and debris left in the parts, which must be done primarily. DEWY-GUARD is then applied inside all windings, insulation separators and metal parts. Under this condition, for the best results, the method of immersion in a DEWY-GUARD filled tank is recommended, the solution should be dried with compressed air after immersion.

Contact Form